FPV Camera Testing Methodology

Published by Mr. D on

In this document, I intend to layout the process for FPV Camera reviews and testing. This FPV Camera testing methodology is to make sure that all tests are performed to the same standards, ensuring the results can be compared.

General

The initial testing will be a rundown of the specifications, and an external view of the camera. We can discuss impressions and build quality at this stage. I am building an FPV Camera testing rig. This will be used to simulate different lighting conditions, to see how well the camera handles them. The entire rig will be inside a box; so there will be no interference from outside light. I will have as good a quality image in the box as possible. However, this is being built, more for testing consistency, rather than exact colour replication.

Classes

The FPV Cameras will be grouped by physical size classes. I have approximate sizes in the table below. FPV Cameras are usually grouped by the manufacturers:

<=14mm2 <=2gPico
14mm2 to 19mm2Nano
19mm2 to 22mm2Micro
22mm2 to 26mm2Mini
22mm2 and aboveStandard

Specifications

Each FPV Camera will have the specs listed. Common specs will also be listed in tables on this site for comparison. We will go through the camera menu, if present; to see what features are available. All tests will be using the default settings.

Capturing the image

The camera signal will be output directly to an ADC, which converts the image to a 1080p, HDMI connection. The HDMI will then be fed in to my computer via a capture device. This sounds like it adds two video devices in line. However, it removed the VTx/VRx from the equation. Also, if I did use the VTx/VRx, I would still need to get the signal from the VRx in to the computer, which would require the ADC and capture card anyway. The image will be presented on screen using a specific, consistent layout.

Image Quality

This will be a look thought the camera lens, with as little things in the way as possible to change the signal. It will be a look in the test box, with an average, sunny day light level. The cameras will all be positioned at the same position, so we can also use this to test viewing angle and fisheye. A still image will be captured for this comparison.

Light based tests

Using an ESP32 controller, there will be tests to see how the camera performs in different lighting situations. The ESP32 is used to make sure that each test can be replicated exactly for each camera. These are visual tests, so the results are open to interpretation by the viewers.

Reaction to bright light

In this test we will simulate looking in to the sun, then back to the base light level. This test will use an LED directly in front of the camera to create the blinding light, while the ambient light remains the same. This test can be run multiple times with different ambient light levels, to be determined when the test platform is built.

Low light handling

In this test, we will lower the ambient light levels of the camera, to see how much of the environment is still visible. This test may not exactly mimic the outside environment, but should give a good idea on how well the FPV camera will perform.

Latancy

At this point, I will not be testing latency. I do not have the equipment necessary to produce an accurate test.

Share:
Categories: Methodologies